Tech Spec

	Standard	XL	Super Chiller
Coils	Two	One	One
Dimensions mm	204(h) * 330(w) *335(d)	204(h) * 330(w) *335(d)	255(h)426(w)346(d)
Weight kg	approx 19kg	approx 20kg	approx 33kg
Fridge Cooling	400W	490W	1200W
Charts	Standard Trimcool 2 pints beer 6 Deg.pdf	XL Trimcool 2 pints beer 5 Deg.pdf Sub Zero Beer Video	Super Cooler test data July 2006.pdf
Performance	Designed to give a Delta T of 4-5°C at two pints per minute. i.e. from 6°C to <2°C.	Designed to give sub zero beer at two pints per minute.	Designed to give open tap sub zero beer at a dispense rate of 2oz per sec.
Factory Stat Settings	US -1.5 diF 0.5 CA 0.0 Ct 10 FAC 120 HT 55 TR 12 LGL 0 UGL 0	US -1.5 diF 1.0 CA 0.0 Ct 0.2 FAC 60 HT 55 TR 12 LGL 0 UGL 1.0	US -2.0 diF 1.0 CA 0.0 Ct 0.2 FAC 60 HT 55 TR 12 LGL 0 UGL 1.0

Parameter Description and Range

US Upper set point -9.9 to 9.9 C

diF Differential 0.1 to 9.9 C

CA Calibration +/-9.9 C

Ct Not applicable N/A

FAC Factor 0 to 255

Ht Max allowable high temperature 55 - 110 C

Tr Min fridge run time 0 to 240 secs

LGL Lower Gradient Limit -9.9 to 9.9

UGL Upper Gradient Limit -9.9 to 9.9

To change the parameter values, switch the power to the unit off, push the temperature set button and keep it pushed whilst switching the power to the unit back on again. The display will flash and intermittently show the figures 888. Once the display stops flashing, the instrument is in parameter mode. To scroll through the parameters push the set point button and to change the values of the parameters use the ‘adjust’ buttons. When finished, release all buttons and wait until the display shows the actual temperature again. Important If the power to the unit is switched off whilst the instrument is still in parameter mode, the system will NOT accept the changes.

The only parameter that should need to be altered from the factory settings is US. The factory setting is —1.5 which delivers product into the glass at approximately 2.0°C. If this setting needs to be altered, it will change in steps of 0.1°C.

ERROR CODES

No power Check fuse in plug and check fuse on unit front is ok and screwed in holder tightly.

PF1 There is a fault with the evaporator block probe. The probe should be changed.

PF2 There is a fault on the high side probe. The high side probe should be changed

HT This error shows the unit is running too hot. The main reason for this is that there is no flow or very low flow in the water return line in the python. Check Python remote pump and water levels. The error code will clear when the temperature drops to an acceptable level.

EE There has been a microprocessor failure in the thermostat. The thermostat should be changed.

Display frozen If the display ‘freezes’ Switch off and switch back on.

If in doubt switch unit off and back on again and if fault persists

call +44(0) 1226 246 999.

A VM Fabrications range of products European Patent no 1048609 US Patent no 6357250B1